Lincoln Electric IM8000 CHECKPOINT - Manual (Page 139)

Summary Report Chapter 11. Weld Listing Tab
IM8000 CheckPoint™ User Manual 11.3
Field Description
Operator ID When an operator begins welding on a Power Wave®, his or her ID or badge
number is entered through Power Wave® Manager or another method. If you want
to generate a list of welds performed by a specific operator, you can enter their ID
in this field.
TIP | The information generated by reports in CheckPoint™ display based on the
individual Welding Power Source or the Container of power sources you have
selected in the Asset Tree. If you would like to see all welds across several
Welding Power Sources that were made by the individual operator, be sure you
have selected a Container and not just a single power source.
Consumable Lot If you want to see a list of all the welds that were made using a specific lot of wire,
you can enter the lot code or serial number for that consumable in this field.
TIP | The information generated by reports in CheckPoint™ display based on the
individual Welding Power Source or the Container of power sources you have
selected in the Asset Tree. If you would like to see all welds across several
Welding Power Sources that could have used this consumable, be sure you have
selected a Container and not just a single power source.
Sort By and
Sort Direction By default, the system sorts your report based on the Start of Weld column in a
descending manner (i.e., most recent first). If you would rather see data in the
report in order of the profiles used for each weld, select Weld Profile from the
drop-down.
To change the direction of that sort, select the appropriate Sort Direction (i.e.,
either Ascending or Descending).
Listing Limit If you want to restrict the size of the report, you can tell CheckPoint™ to limit the
number of records that appear in the report. Enter that maximum number of
records in the Listing Limit field.
NOTE | If the resulting report contains more records than you indicated in the
Listing Limit field, the system does not show the remaining records. Be sure your
limit is inclusive of all your data.
Data on the Report
The information on the Summary report provides you with the details on the individual welds performed on
a Welding Power Source. The information is available when you select a single Welding Power Source or a
Container.
TIP | If you select a Container in the Asset Tree, you can click the
Welder column header to sort the list by individual power
source.