Lincoln Electric IM8000 CHECKPOINT - Manual (Page 135)

Overview Report Chapter 10. Assembly Listing Tab
IM8000 CheckPoint™ User Manual 10.5
Field Description
Welds Out of Limits This column displays the number of welds (from the Welds part of the
Welds/Expected column) where limits were enabled, and the weld went outside
those limits.
If limits were not enabled for a weld, CheckPoint™ does not take that weld into
consideration for this column. If none of the welds in the Welds part of the
Welds/Expected column had limits enabled, the Welds Out of Limits column is
“0”.
For example, the Welds/Expected column displays 62 of 89 welds. Out of the 62
welds performed, 20 of those welds had limits enabled when they were
performed. Of those 20 welds, 15 were outside the limits set for the weld. The
Welds Out of Limits column would display 15.
WeldScore™ This column displays the average WeldScore™ for the welds listed in the Welds
part of the Welds/Expected column where WeldScore™ was enabled. If
WeldScore™ was not enabled for a weld, it is not taken into consideration for
this column. If none of the welds in the Welds part of the Welds/Expected
column had WeldScore™ enabled, the WeldScore™ column is empty.
For example, the Welds/Expected column displays 62 of 89 welds. Out of the
62 welds performed, 42 of those welds had WeldScore™ enabled when they
were performed. The WeldScore™ column shows the average WeldScore™
for those 42 welds.
Deposition (lb) This column displays the amount of wire (in pounds or kilograms) that was
deposited for the welds made during this instance of the Weld Sequence.
Errors The errors columns displays the current number of errors recorded for this
instance of the Weld Sequence.
Weld Sequence Drilldown
Once you have a list of the assemblies (Figure 10.2 on page 10.3), you can click the link on the instance of
the Weld Sequence to display a list of all the welds that went into that sequence (Figure 10.3).
Figure 10.3 List of Individual Welds in Weld Sequence Instance