Lincoln Electric IM8000 CHECKPOINT - Manual (Page 35)

Validate User Information in CheckPoint™ Chapter 3. Setting up CheckPoint™
IM8000 CheckPoint™ User Manual 3.3
Procedure Details
1. Click Get Started on the Home page. See Figure 3.1 on page 3.1. The Getting Started page
opens (Figure 3.2).
2. Read through each step on the page and
click the link in the final step to begin.
The New Account page opens (Figure 3.3). This is
where you will create the administrator user account.
NOTE | The first user created is the CheckPoint™
administrator account. This user has access to set up
other users and add Welding Power Sources in
CheckPoint™.
3. Complete the information on the New
Account page and click Submit.
After you submit the information, the system sends a
verification e-mail to the e-mail address you entered.
Validate User Information in CheckPoint™
Validating your user information is simple and gets you closer to using CheckPoint™ to monitor your
welding operations. Check your e-mail inbox for a message from CheckPoint™. Open the e-mail and click
the validation link contained within it (Figure 3.4).
Figure 3.4 Validation E-mail
TIP | If you do not see an e-mail from CheckPoint™, check your
Junk Mail folder.
Once you click the validation link, the administrator account is now active and you can add the first Welding
Power Source and register your company in the data center.