Lincoln Electric IM8000 CHECKPOINT - Manual (Page 28)

Chapter 2. Preparing for CheckPoint™ Enable CheckPoint™ for a Power Source
2.6 CheckPoint™ User Manual IM8000
Procedure Details
If this is a new installation (or once the old version
is removed), the system displays the installation
welcome window.
7. Click Next on the Welcome screen to move to
the License Agreement and continue the
installation.
8. You must accept the License Agreement and
click Next to continue.
9. Leave the default value in the Destination
Folder field and click Install.
The system extracts files and installs the Power
Wave® Utilities on your computer. Once it is
complete, the final page of the Setup Wizard
opens.
10. Click the Finish button to exit the installer. Congratulations! You have installed Power Wave®
Manager and can now configure your Welding
Power Source.
Enable CheckPoint™ for a Power Source
Now that you have upgraded the firmware on the Welding Power Source and installed the latest version of
Power Wave® Manager on your computer, you can now use Power Wave® Manager to enable CheckPoint™
on the Welding Power Source.
Establish Connection to the Welding Power Source
When you updated the firmware on the Welding Power Source (page 2.1), you needed to tell the Update
Utility where to find the Welding Power Source on your network. Now you need to tell Power Wave®
Manager where to find the Welding Power Source on your network so you can enable CheckPoint™ for that
power source.