Yokogawa DAQWORX - Manual (Page 54)

3-2 IM WX13-01E
3.2 Scanning and Recording
For the procedure for starting AddTrigger, see section 2.2.
For the procedure for selecting the project, see section 2.3.
Record stop
Record start
Scan
Starting the Scanning Operation
Procedure
Click Scan start/stop on the Launcher’s toolbar or choose Scan from the Logger menu.
AddTrigger retrieves all the data of the related channels that is scanned and held by the
data logging software.
Scanning starts.
Note
• When scanning is started, the monitor server of the data logging software displays the host
name of the PC on which AddTrigger is running.
• If initial communication with the device to be connected fails, a reattempt is made within 30
seconds after the communication failure was recognized. Additional time is required from
the start of communication until failure is recognized.
Automatically Starting the Scan Operation
If Only scan measurement data is selected in the project, scanning starts when the
Launcher is started (see section 2.3).
Stopping the Scanning Operation
Procedure
While scanning is in progress, click Scan start/stop on the Launcher’s toolbar or choose
Scan from the Logger menu.
Scanning stops.
Note
• When scanning is stopped, the host name (of the PC on which AddTrigger is running) that is
displayed on the monitor server of the data logging software disappears.
• You cannot stop the scan operation while recording is in progress.