Software configuration – Watlow EZ-ZONE RME User Manual
Page 91
Watlow EZ-ZONE
®
RME Module
•
88
•
Chapter 6 Features
Software Configuration
Using EZ-ZONE
®
Configurator Software
To enable a user to configure the RME module using
a personal computer (PC), Watlow has provided free
software for your use. If you have not yet obtained a
copy of this software insert the CD (Controller Sup-
port Tools) into your CD drive and install the soft-
ware. Alternatively, if you are viewing this document
electronically and have a connection to the internet
simply click on the link below and download the soft-
ware from the Watlow web site free of charge.
Once the software is installed double click on the
EZ-ZONE Configurator icon placed on your desktop
during the installation process. If you cannot find
the icon follow the steps below to run the software:
1. Move your mouse to the "Start" button
2. Place the mouse over "All Programs"
3. Navigate to the "Watlow" folder and then the sub-
folder "EZ-ZONE Configurator"
4. Click on EZ-ZONE Configurator to run.
The first screen that will appear is shown below.
If the PC is already physically connected to the RME
module click the next button to go on-line.
Note:
When establishing communications from PC to the
RME module an interface converter will be required.
The Standard Bus network uses EIA-485 as the inter-
face. Most PCs today would require a USB to EIA-485
converter. However, some PCs may still be equipped
with EIA-232 ports, therefore an EIA-232 to EIA-485
converter would be required.
As can be seen in the above screen shot the soft-
ware provides the user with the option of download-
ing a previously saved configuration as well as the
ability to create a configuration off-line to download
later. The screen shots that follow will take the user
on-line.
After clicking the next button above it is neces-
sary to define the communications port on the PC to
use.
The available options allow the user to select "Try
them all" or to use a specific known communications
port. After installation of your converter if you are
not sure which communications port was allocated
select "Try them all" and then click next. The screen
to follow shows that the software is scanning for
devices on the network and that progress is being
made.
When complete the software will display all of the
available devices found on the network as shown be-
low.