Teledyne GFC-7000T - Trace CO2 Analyzer - manual - Manual (Page 88)

Operating Instructions Model GFC7000TA Carbon Dioxide Analyzer
Teledyne Analytical Instruments 70
6.5. SETUP
 CFG: Viewing the Analyzer’s Configuration
Information
Pressing the CFG button displays the instrument configuration information. This display lists the analyzer
model, serial number, firmware revision, software library revision, CPU type and other information. Use
this information to identify the software and hardware when contacting customer service. Special
instrument or software features or installed options may also be listed here.
SAMPLE* RANGE = 500.000 PPB CO2 =X.XXX
< TST TST > CAL SETUP
SAMPLE
PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SAMPLE T360 CO2 ANALYZER
NEXT PREV EXIT
Press EXIT at
any time to
return to SETUP
menu
Press EXIT at any
time to return to the
SAMPLE display
Press NEXT and PREV to scroll through the
following list of Configuration information:
 MODEL NAME
 PART NUMBER
 SERIAL NUMBER
 SOFTWARE REVISION
 LIBRARY REVISION
 iCHIP SOFTWARE REVISION 1
 HESSEN PROTOCOL REVISION 1
 ACTIVE SPECIAL SOFTWARE
OPTIONS 1
 CPU TYPE
 DATE FACTORY CONFIGURATION
SAVED
1 Only appears if relevant option of Feature is active.
6.6. SETUP
 ACAL: Automatic Calibration
Instruments with one of the internal valve options installed can be set to automatically run calibration
procedures and calibration checks. These automatic procedures are programmed using the submenus
and functions found under the ACAL menu.
A menu tree showing the ACAL menu’s entire structure can be found in Appendix A-1 of this manual.
Instructions for using the ACAL feature are located in the Section 7.6 of this manual along with all other
information related to calibrating the analyzer.