Teledyne GFC-7000T - Trace CO2 Analyzer - manual - Manual (Page 148)

Operating Instructions Model GFC7000TA Carbon Dioxide Analyzer
Teledyne Analytical Instruments 130
V
+DC Gnd
V OUT +
V OUT -
V IN +
V IN -
Recording
Device
ANALYZER
See Table 3-1 for
pin assignments
of Analog Out
connector on the
rear panel
Figure 6-11: Setup for Calibrating Analog Voltage Outputs
To make these adjustments, the AOUT auto-calibration feature must be turned off (Section 6.13.4.2).
Activate the ANALOG I/O CONFIGURATION MENU (See Section 6.13.1), then press: