Teledyne GFC-7000T - Trace CO2 Analyzer - manual - Manual (Page 169)

Operating Instructions Model GFC7000TA Carbon Dioxide Analyzer
Teledyne Analytical Instruments 151
To initialize the modem press:
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG ALRM EXIT
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SAMPLE* RANGE = 500.000 PPM CO2 =X.XXX
< TST TST > CAL SETUP
SETUP X.X COMMUNICATIONS MENU
ID INET
COM1 COM2 EXIT
EXIT returns to
the previous
menu
SETUP X.X COM1 MODEM INIT:AT Y  &D &H
SET> EDIT EXIT
SETUP X.X COM1 INITIALIZE MODEM
SET> INIT EXIT
SETUP X.X COM1 MODE:0
SET> EDIT EXIT
SETUP X.X COM1 BAUD RATE:19200
SET> EDIT EXIT
EXIT returns to the
Communications Menu.
SETUP X.X INITIALIZING MODEM
SET> INIT EXIT
6.15.2.7. COM Port Password Security
In order to provide security for remote access of the GFC 7000TA, a LOGON feature can be enabled to
require a password before the instrument will accept commands. This is done by turning on the
SECURITY MODE
(Mode 4, Section 6.11.5). Once the SECURITY MODE is enabled, the following items
apply.
 A password is required before the port will respond or pass on commands.
 If the port is inactive for one hour, it will automatically logoff, which can also be achieved with the
LOGOFF command.
 Three unsuccessful attempts to log on with an incorrect password will cause subsequent logins to be
disabled for 1 hour, even if the correct password is used.
 If not logged on, the only active command is the '?' request for the help screen.
 The following messages will be returned at logon:
 LOGON SUCCESSFUL - Correct password given
 LOGON FAILED - Password not given or incorrect
 LOGOFF SUCCESSFUL - Connection terminated successfully
To log on to the Model GFC 7000TA analyzer with SECURITY MODE feature enabled, type:
LOGON 940331
940331 is the default password. To change the default password, use the variable RS232_PASS issued
as follows:
V RS232_PASS=NNNNNN