Teledyne GFC-7000T - Trace CO2 Analyzer - manual - Manual (Page 31)

Getting Started Model GFC7000TA Carbon Dioxide Analyzer
Teledyne Analytical Instruments 13
Table 3-1: Display and Touchscreen Control Description
Field Description/Function
Status LEDs indicating the states of Sample, Calibration and Fault, as follows:
Name Color
State Definition
SAMPLE Green
Off
On
Blinking Unit is not operating in sample mode, DAS is disabled.
Sample Mode active; Front Panel Display being updated; DAS data
being stored.
Unit is operating in sample mode, front panel display being updated,
DAS hold-off mode is ON, DAS disabled
CAL Yellow
Off
On
Blinking Auto Cal disabled
Auto Cal enabled
Unit is in calibration mode
FAULT Red
Off
Blinking No warnings exist
Warnings exist
Conc
Displays the actual concentration of the sample gas currently being measured by the analyzer in the
currently selected units of measure
Mode Displays the name of the analyzer’s current operating mode
Param
Displays a variety of informational messages such as warning messages, operational data, test function
values and response messages during interactive tasks.
Control Buttons Displays dynamic, context sensitive labels on each button, which is blank when inactive until applicable.
Figure 3-3 shows how the front panel display is mapped to the menu charts illustrated in this manual. The
Mode, Param (parameters), and Conc (gas concentration) fields in the display screen are represented
across the top row of each menu chart. The eight touchscreen control buttons along the bottom of the
display screen are represented in the bottom row of each menu chart.