ZyXEL Communications ZyXEL ZyWALL 5 - Manual (Page 77)

ZyWALL 5 User’s Guide
76 Chapter 3 Wizard Setup
3.3.1 Network Setting
Two active SAs cannot have the local and remote IP address(es) both the same. Two active
SAs can have the same local or remote IP address, but not both. You can configure multiple
SAs between the same local and remote IP addresses, as long as only one is active at any time.
Figure 17 VPN Wizard : Network Setting
The following table describes the labels in this screen.
Table 13 VPN Wizard : Network Setting
LABEL DESCRIPTION
Network Policy
Property
Active If the Active check box is selected, packets for the tunnel trigger the ZyWALL to build
the tunnel.
Clear the Active check box to turn the network policy off. The ZyWALL does not apply
the policy. Packets for the tunnel do not trigger the tunnel.
Name Type up to 32 characters to identify this VPN network policy. You may use any
character, including spaces, but the ZyWALL drops trailing spaces.
Network Policy
Setting
Local Network Local IP addresses must be static and correspond to the remote IPSec router's
configured remote IP addresses.
Select Single for a single IP address. Select Range IP for a specific range of IP
addresses. Select Subnet to specify IP addresses on a network by their subnet mask.