beautypg.com

Table 46 wireless logs, Table 47 ipsec logs – ZyXEL Communications ZyXEL ZyWALL 5 User Manual

Page 647

background image

ZyWALL 5 User’s Guide

646

Appendix Q Log Descriptions

Remote Management: WWW denied

Attempted use of WWW service was blocked according to

remote management settings.

Remote Management: HTTPS denied

Attempted use of HTTPS service was blocked according to

remote management settings.

Remote Management: SSH denied

Attempted use of SSH service was blocked according to

remote management settings.

Remote Management: ICMP Ping

response denied

Attempted use of ICMP service was blocked according to

remote management settings.

Remote Management: SNMP denied

Attempted use of SNMP service was blocked according to

remote management settings.

Remote Management: DNS denied

Attempted use of DNS service was blocked according to

remote management settings.

Table 46 Wireless Logs

LOG MESSAGE

DESCRIPTION

WLAN MAC Filter Fail

The MAC filter blocked a wireless station from connecting to the

device.

WLAN MAC Filter Success

The MAC filter allowed a wireless station to connect to the device.

WLAN STA Association

A wireless station associated with the device.

WLAN STA Association List Full

The maximum number of associated wireless clients has been

reached.

WLAN STA Association Again

The SSID and time of association were updated for an wireless

station that was already associated.

Table 47 IPSec Logs

LOG MESSAGE

DESCRIPTION

Discard REPLAY packet

The router received and discarded a packet with an incorrect

sequence number.

Inbound packet
authentication failed

The router received a packet that has been altered. A third party may

have altered or tampered with the packet.

Receive IPSec packet,
but no corresponding
tunnel exists

The router dropped an inbound packet for which SPI could not find a

corresponding phase 2 SA.

Rule <%d> idle time out,
disconnect

The router dropped a connection that had outbound traffic and no

inbound traffic for a certain time period. You can use the "ipsec timer

chk_conn" CI command to set the time period. The default value is 2

minutes.

WAN IP changed to

The router dropped all connections with the “MyIP” configured as

“0.0.0.0” when the WAN IP address changed.

Inbound packet decryption failed Please check the algorithm configuration.

Table 45 Remote Management Logs

LOG MESSAGE

DESCRIPTION