ZyXEL Communications ZyXEL ZyWALL 5 - Manual (Page 434)

ZyWALL 5 User’s Guide
Chapter 31 Remote Node Setup 433
C
H A P T E R
31
Remote Node Setup
This chapter shows you how to configure a remote node.
31.1 Introduction to Remote Node Setup
A remote node is required for placing calls to a remote gateway. A remote node represents
both the remote gateway and the network behind it across a WAN connection. Note that when
you use menu 4 to set up Internet access, you are actually configuring a remote node. The
following describes how to configure Menu 11.1 - Remote Node Profile, Menu 11.1.2 -
Remote Node Network Layer Options, Menu 11.1.4 - Remote Node Filter and Menu
11.1.5 - Traffic Redirect Setup.
31.2 Remote Node Setup
From the main menu, select menu option 11 to open Menu 11 - Remote Node Setup (shown
below).
Then enter 1 to open Menu 11.1 - Remote Node Profile and configure the setup for your
WAN port. Enter 2 to open Menu 11.2 Remote Node Profile (Backup ISP) and configure the
setup for your Dial Backup port connection (see
Chapter 27 on page 405 ).
Figure 244 Menu 11: Remote Node Setup
31.3 Remote Node Profile Setup
The following explains how to configure the remote node profile menu.
Menu 11 - Remote Node Setup
1. ChangeMe (ISP, SUA)
2. -Dial (BACKUP_ISP, SUA)
Enter Node # to Edit: