ZyXEL Communications ZyXEL ZyWALL 5 - Manual (Page 416)

ZyWALL 5 User’s Guide
Chapter 27 WAN and Dial Backup Setup 415
27.10 Remote Node Filter
Move the cursor to the field Edit Filter Sets in menu 11.2, and then press [SPACE BAR] to
set the value to Yes. Press [ENTER] to open Menu 11.2.4 - Remote Node Filter
.
Use menu 11.2.4 to specify the filter set(s) to apply to the incoming and outgoing traffic
between this remote node and the ZyWALL to prevent certain packets from triggering calls.
You can specify up to four filter sets separated by commas, for example, 1, 5, 9, 12, in each
filter field. Note that spaces are accepted in this field. Please refer to
Chapter 35 on page 465
for more information on defining the filters.
Figure 228 Menu 11.2.4: Remote Node Filter
Menu 11.2.4 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL: