ZyXEL Communications ZyXEL ZyWALL 5 - Manual (Page 407)

ZyWALL 5 User’s Guide
406 Chapter 27 WAN and Dial Backup Setup
The following table describes the fields in this screen.
27.3 Dial Backup
The Dial Backup port can be used in reserve, as a traditional dial-up connection should the
broadband connection to the WAN port fail. To set up the auxiliary port (Dial Backup) for use
in the event that the regular WAN connection is dropped, first make sure you have set up the
switch and port connection (see the Quick Start Guide), then configure
1 Menu 2 - WAN Setup,
2 Menu 2.1 - Advanced WAN Setup and
3 Menu 11.2 - Remote Node Profile (Backup ISP).
Refer also to the section about traffic redirect for information on an alternate backup WAN
connection.
27.4 Configuring Dial Backup in Menu 2
From the main menu, enter 2 to open menu 2.
Table 152 MAC Address Cloning in WAN Setup
FIELD DESCRIPTION
MAC Address
Assigned By Press [SPACE BAR] and then [ENTER] to choose one of two methods to assign a
MAC Address. Choose Factory Default to select the factory assigned default MAC
Address. Choose IP address attached on LAN to use the MAC Address of that
computer whose IP you give in the following field.
IP Address This field is applicable only if you choose the IP address attached on LAN method
in the Assigned By field. Enter the IP address of the computer on the LAN whose
MAC you are cloning.
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to
save your configuration, or press [ESC] at any time to cancel.