ZyXEL Communications ZyXEL ZyWALL 5 - Manual (Page 410)

ZyWALL 5 User’s Guide
Chapter 27 WAN and Dial Backup Setup 409
27.6 Remote Node Profile (Backup ISP)
Enter 2 in Menu 11 - Remote Node Setup to open Menu 11.2 - Remote Node Profile
(Backup ISP) (shown below) and configure the setup for your Dial Backup port connection.
Figure 224 Menu 11.2: Remote Node Profile (Backup ISP)
Table 155 Advanced WAN Port Setup: Call Control Parameters
FIELD DESCRIPTION
Call Control
Dial Timeout (sec) Enter a number of seconds for the ZyWALL to keep trying to set up an outgoing
call before timing out (stopping). The ZyWALL times out and stops if it cannot set
up an outgoing call within the timeout value.
Retry Count Enter a number of times for the ZyWALL to retry a busy or no-answer phone
number before blacklisting the number.
Retry Interval (sec) Enter a number of seconds for the ZyWALL to wait before trying another call after
a call has failed. This applies before a phone number is blacklisted.
Drop Timeout (sec) Enter a number of seconds for the ZyWALL to wait before dropping the DTR
signal if it does not receive a positive disconnect confirmation.
Call Back Delay
(sec)
Enter a number of seconds for the ZyWALL to wait between dropping a callback
request call and dialing the co-responding callback call.
Menu 11.2 - Remote Node Profile (Backup ISP)
Rem Node Name= Dial Edit PPP Options= No
Active= No
Edit IP= No
Outgoing: Edit Script Options= No
My Login= ChangeMe
My Password= ******** Telco Option:
Retype to Confirm= ******** Allocated Budget(min)= 0
Authen= CHAP/PAP Period(hr)= 0
Pri Phone #= 0 Schedules=
Sec Phone #= Nailed-Up Connection= No
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= 100
Press ENTER to Confirm or ESC to Cancel: