ZyXEL Communications ZyXEL ZyWALL 5 - Manual (Page 290)

ZyWALL 5 User’s Guide
Chapter 17 Network Address Translation (NAT) 289
17.4 Configuring Address Mapping
Ordering your rules is important because the ZyWALL applies the rules in the order that you
specify. When a rule matches the current packet, the ZyWALL takes the corresponding action
and the remaining rules are ignored. If there are any empty rules before your new configured
rule, your configured rule will be pushed up by that number of empty rules. For example, if
you have already configured rules 1 to 6 in your current set and now you configure rule
number 9. In the set summary screen, the new rule will be rule 7, not 9. Now if you delete rule
4, rules 5 to 7 will be pushed up by 1 rule, so old rules 5, 6 and 7 become new rules 4, 5 and 6.
To change your ZyWALL’s Address Mapping settings, click NAT, then the Address
Mapping tab. The screen appears as shown (some of the screen’s blank rows are not shown).
Figure 139 Address Mapping
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to begin configuring this screen afresh.
Table 93 NAT Overview (continued)
LABEL DESCRIPTION