ZyXEL Communications ZyXEL ZyWALL 5 - Manual (Page 423)

ZyWALL 5 User’s Guide
422 Chapter 28 LAN Setup
28.5 Wireless LAN Setup
Use menu 3.5 to set up your ZyWALL as the wireless access point.
Note: If you are configuring the ZyWALL from a computer connected to the wireless
LAN and you change the ZyWALL’s ESSID or WEP settings, you will lose your
wireless connection when you press [ENTER] to confirm. You must then
change the wireless settings of your computer to match the ZyWALL’s new
settings.
From the main menu, enter 3 to open Menu 3 - LAN Setup to configure the Wireless LAN
setup. To edit the wireless LAN configuration, enter 5 to open Menu 3.5 - Wireless LAN
Setup as shown next.
Figure 234 Menu 3.5: Wireless LAN Setup
Note: The settings of all client stations on the wireless LAN must match those of the
ZyWALL.
Outgoing
Protocol Filters
Enter the filter set(s) you wish to apply to the outgoing traffic between this node and
the ZyWALL.
When you have completed this menu, press [ENTER] at the prompt [Press ENTER to Confirm…] to
save your configuration, or press [ESC] at any time to cancel.
Table 162 Menu 3.2.1: IP Alias Setup (continued)
FIELD DESCRIPTION
Menu 3.5 - Wireless LAN Setup
Enable Wireless LAN= No
ESSID= Wireless
Hide ESSID= No
Channel ID= CH06 2437MHz
RTS Threshold= 2432
Frag. Threshold= 2432
WEP= Disable
Default Key= N/A
Key1= N/A
Key2= N/A
Key3= N/A
Key4= N/A
Edit MAC Address Filter= No
Press ENTER to Confirm or ESC to Cancel: