ZyXEL Communications ZyXEL ZyWALL 5 - Manual (Page 298)

ZyWALL 5 User’s Guide
Chapter 17 Network Address Translation (NAT) 297
5 Only Jane can connect to the Real Audio server until the connection is closed or times
out. The ZyWALL times out in three minutes with UDP (User Datagram Protocol) or two
hours with TCP/IP (Transfer Control Protocol/Internet Protocol).
To change your ZyWALL’s trigger port settings, click NAT and the Port Triggering tab. The
screen appears as shown.
Figure 145 Port Triggering
The following table describes the labels in this screen.
Table 98 Port Triggering
LABEL DESCRIPTION
# This is the rule index number (read-only).
Name Type a unique name (up to 15 characters) for identification purposes. All characters are
permitted - including spaces.
Incoming Incoming is a port (or a range of ports) that a server on the WAN uses when it sends out
a particular service. The ZyWALL forwards the traffic with this port (or range of ports) to
the client computer on the LAN that requested the service.
Start Port Type a port number or the starting port number in a range of port numbers.
End Port Type a port number or the ending port number in a range of port numbers.
Trigger The trigger port is a port (or a range of ports) that causes (or triggers) the ZyWALL to
record the IP address of the LAN computer that sent the traffic to a server on the WAN.
Start Port Type a port number or the starting port number in a range of port numbers.