ZyXEL Communications ZyXEL ZyWALL 5 - Manual (Page 626)

ZyWALL 5 User’s Guide
Appendix L Firewall Commands 625
config edit firewall set #> rule destaddr-
subnet mask> This command sets a rule to have the
ZyWALL check for traffic with a particular
subnet destination (defined by IP address and
subnet mask).
config edit firewall set #> rule destaddr-
range ip address> This command sets a rule to have the
ZyWALL check for traffic going to this range of
addresses.
config edit firewall set #> rule TCP destport-
single This command sets a rule to have the
ZyWALL check for TCP traffic with this
destination address. You may repeat this
command to enter various, non-consecutive
port numbers.
config edit firewall set #> rule TCP destport-
range #> This command sets a rule to have the
ZyWALL check for TCP traffic with a
destination port in this range.
config edit firewall set #> rule UDP destport-
single This command sets a rule to have the
ZyWALL check for UDP traffic with this
destination address. You may repeat this
command to enter various, non-consecutive
port numbers.
config edit firewall set #> rule UDP destport-
range #> This command sets a rule to have the
ZyWALL check for UDP traffic with a
destination port in this range.
Delete
config delete firewall e-mail This command removes all of the settings for
e-mail alert.
config delete firewall attack This command resets all of the attack
response settings to their defaults.
config delete firewall set
This command removes the specified set from
the firewall configuration.
config delete firewall set
rule This command removes the specified rule in a
firewall configuration set.
Table 30 Firewall Commands (continued)
FUNCTION COMMAND DESCRIPTION