ZyXEL Communications ZyXEL ZyWALL 5 - Manual (Page 408)

ZyWALL 5 User’s Guide
Chapter 27 WAN and Dial Backup Setup 407
Figure 222 Menu 2: Dial Backup Setup
The following table describes the fields in this menu.
27.5 Advanced WAN Setup
Note: Consult the manual of your WAN device connected to your Dial Backup port for
specific AT commands.
Menu 2 - WAN Setup
MAC Address:
Assigned By= Factory default
IP Address= N/A
Dial-Backup:
Active= No
Port Speed= 115200
AT Command String:
Init= at&fs0=0
Edit Advanced Setup= No
Press ENTER to Confirm or ESC to Cancel:
Table 153 Menu 2: Dial Backup Setup
FIELD DESCRIPTION
Dial-Backup:
Active Use this field to turn the dial-backup feature on (Yes) or off (No).
Port Speed Press [SPACE BAR] and then press [ENTER] to select the speed of the connection
between the Dial Backup port and the external device.
Available speeds are:
9600, 19200, 38400, 57600, 115200 or 230400 bps.
AT Command
String:
Init Enter the AT command string to initialize the WAN device. Consult the manual of your
WAN device connected to your Dial Backup port for specific AT commands.
Edit Advanced
Setup
To edit the advanced setup for the Dial Backup port, move the cursor to this field;
press the [SPACE BAR] to select Yes and then press [ENTER] to go to Menu 2.1 -
Advanced Setup.
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to
save your configuration, or press [ESC] at any time to cancel.