ZyXEL Communications ZyXEL ZyWALL 5 - Manual (Page 138)

ZyWALL 5 User’s Guide
Chapter 7 WAN Screens 137
Figure 49 Traffic Redirect
The following table describes the labels in this screen.
7.7 Configuring Dial Backup
To change your ZyWALL’s Dial Backup settings, click WAN, then the Dial Backup tab. The
screen appears as shown.
Table 39 Traffic Redirect
LABEL DESCRIPTION
Active Select this check box to have the ZyWALL use traffic redirect if the normal WAN
connection goes down.
Backup
Gateway IP
Address
Type the IP address of your backup gateway in dotted decimal notation. The ZyWALL
automatically forwards traffic to this IP address if the ZyWALL's Internet connection
terminates.
Check WAN IP
Address
Configuration of this field is optional. If you do not enter an IP address here, the
ZyWALL will use the default gateway IP address. Configure this field to test your
ZyWALL's WAN accessibility. Type the IP address of a reliable nearby computer (for
example, your ISP's DNS server address).
Fail Tolerance Type how many WAN connection checks can fail (1 to 10) before the connection is
considered "down" (not connected). The ZyWALL still checks a "down" connection to
detect if it reconnects.
Period The ZyWALL tests a WAN connection by periodically sending a ping to either the
default gateway or the address in the Check WAN IP Address field.
Type a number of seconds (5 to 300) to set the time interval between checks. Allow
more time if your destination IP address handles lots of traffic.
Timeout Type the number of seconds (1 to 10) for your ZyWALL to wait for a response to the
ping before considering the check to have failed. This setting must be less than the
Period. Use a higher value in this field if your network is busy or congested.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to begin configuring this screen afresh.