ZyXEL Communications ZyXEL ZyWALL 5 - Manual (Page 348)

ZyWALL 5 User’s Guide
Chapter 21 Remote Management 347
Figure 181 FTP
The following table describes the labels in this screen.
21.14 Configuring SNMP
Simple Network Management Protocol is a protocol used for exchanging management
information between network devices. SNMP is a member of the TCP/IP protocol suite. Your
ZyWALL supports SNMP agent functionality, which allows a manager station to manage and
monitor the ZyWALL through the network. The ZyWALL supports SNMP version one
(SNMPv1). The next figure illustrates an SNMP management operation. SNMP is only
available if TCP/IP is configured.
Note: SNMP is only available if TCP/IP is configured.
Table 121 FTP
LABEL DESCRIPTION
Server Port You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Server Access Select the interface(s) through which a computer may access the ZyWALL using this
service.
Secure Client IP
Address
A secure client is a “trusted” computer that is allowed to communicate with the
ZyWALL using this service.
Select All to allow any computer to access the ZyWALL using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyWALL using this service.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to begin configuring this screen afresh.