Paxar 9474 - Manual (Page 30)

L o a d i n g t h e R i b b o n C a s s e t t e
This section tells you how to load a ribbon cassette on machines
equipped to use ribbon cassettes. If your machine has a ribbon
roll adapter, see "Loading a Ribbon Roll".
DO NOT load a ribbon cassette when printing on thermal direct
supplies.
1. Open the front panel by pulling the panel tab.
2. Turn the printhead lever to open the printhead. (Also see the
supply loading figure inside the front panel of the printer.)
If the printer has supplies loaded, pull the
leading edge back to the upper guide before
loading the ribbon cassette.
3. Remove the old ribbon
cassette if necessary.
4. Remove the new ribbon
cassette from the package.
5. Use your finger to pull the
ribbon leader out about four
inches.
Printhead
Lever
Upper
Guide
Loading a Ribbon 3-5