Paxar J640 User Manual

Loading continuous supplies

J640/J641 Operator’s Handbook Addendum

This addendum describes how to load continuous strip labels into
your printer and how to clean your printer using the cleaning pen
provided. Read this addendum and store it with your Operator’s
Handbook.

Loading Continuous Supplies –––––––––––––––––––––––––––––––––

Use only paper labels when using this loading method. Also, before
loading labels, make sure the label path is clean. See Chapter 4,
"Care and Maintenance," in your

Operator’s Handbook

First follow steps 1-4 of "Loading for Peel Mode," in Chapter 2 of
your

Operator’s Handbook

. After you complete step 4, follow the

steps below:

1. Feed 4"-5" of the label strip

through the upper opening in
the label guide (Figure 1).

2. Close the printer.

3. Separate the label from the

backing paper (Figure 2).

4. Use the tear bar to tear the

label so it is square with the
backing paper. Don’t tear the
backing paper (Figure 2).

5. Open the printer.

6. Pull the backing paper out of

the upper opening in the label
guide and feed it through the
lower opening.

7. Back up the leading edge of

the label so it rests 1"-2"
behind the black rubber roller.

Lower
Opening

Label
Guide

Upper
Opening

Figure 1

118169 10/95

Label

Tear
Bar

Backing
Paper

Figure 2