Savin 3799nf - Manual (Page 249)

Initial Set Up
237
7
❒ You can use up to 20 characters
when registering one item of Spec-
ified Senders for the G3 communi-
cation, and 24 characters for the G4
communication. You can also spec-
ify wildcards. See p.98 “Entering
Characters”, .
❒ If the Specified Sender's fax ma-
chine is of the same make as your
machine, register the sender's
name registered to their machine.
If the Specified Sender's fax ma-
chine is of a different make, regis-
ter the fax number.
❒ You can check the sender's name
or sender's fax number registered
to the fax machines of Specified
Senders on the Journal. See p.50
“Printing the Journal”.
❒ You can change the current setting
by following the same procedure
for making a new setting. Change
the values of settings according to
your needs.
Reference
p.58 “TX/RX File Save”
Setting up TX/RX File Save
AAAA
Press the
{{{{User Tools}}}} key.
BBBB
Enter the code for "Key Op.
Tools" with the number keys then
press the
{{{{q q q q}}}} key.
The "Key Op. Tools" main menu
appears.
CCCC
Enter the code for "Initial Set Up"
with the number keys.
The "Initial Set Up" menu appears.
DDDD
Enter the code for "TX/RX File
Save" with the number keys.
Note
❒ If "TX/RX File Save" is not
shown, press [ ↑↑↑↑Prev.] or [↓↓↓↓Next]
until it is.
EEEE
Press [Sender].
Note
❒ If you do not wish to register a
Specified Sender, proceed to
step
O.
❒ If you do not register any Speci-
fied Senders, all incoming faxes
are received using TX/RX File
Save.
FFFF
Enter the code for "Program Send-
er" with the number keys.