HP 9100 series User Manual
Page 27
ENWW
Installing memory modules 25
11
See
Turning on accessories in the printer driver
for information about turning on DIMMs in
the printer driver.
To verify that the DIMM is installed correctly
1
Make sure that the power cord and any cables are plugged in and that the power is turned
on.
2
Make sure that
READY
appears on the control-panel display. If an error message appears,
a DIMM might have been installed incorrectly.
3
Print a Configuration page (see
). In the memory section, compare the
memory amount to the memory amount on the Configuration page that you printed before
installing the DIMM. If the amount of memory has not increased, one of the following
problems might have occurred:
• The DIMM might not be installed correctly. Remove the DIMM and repeat the
installation procedure.
• The DIMM might be defective. Try a new DIMM.