Installing memory modules – HP 9100 series User Manual
Page 25
ENWW
Installing memory modules 23
Installing memory modules
If you often print complex graphics or PostScript
®
(PS) documents, or if you print with the
auto-duplex unit, you might want to add more memory to the all-in-one. Adding memory gives
the all-in-one the ability to process these more complex print jobs, but might not increase
processing speed.
The all-in-one contains 128 MB of memory. It has two DIMM slots that accept 64 MB or
128 MB of RAM. The all-in-one can support up to 384 MB of memory (including the 128 MB in
the all-in-one). You can find out how much memory is installed by printing a Configuration
page (see
). Additional memory is available for purchase as an accessory
(see
Ordering HP accessories and supplies
for information about ordering).
CAUTION
The DIMMs contain electronic components that can be damaged by static electricity. To
prevent the buildup of static electricity, maintain frequent contact with any bare sheet metal
surface on the all-in-one. If possible, wear a grounding wrist strap (or similar device). Handle
the DIMMs carefully at all times. Avoid touching electronic components or circuit paths. Failure
to follow these recommendations could result in damage to the parts.
To install a DIMM
1
If you have not already done so, print a Configuration page to find out how much memory
is available in the all-in-one before adding more memory (see
2
Press
(P
OWER
) to turn off the all-in-one.
3
Unplug the power cord and disconnect any cables.
4
On the left side of the all-in-one, unlatch and remove the side cover.