Solving fax problems, General problems with faxing – HP 9100 series User Manual
Page 177
ENWW
Solving fax problems 175
Solving fax problems
If the following topics do not help, see
for information about
HP support.
Note
If you are starting a fax from a computer, see the software Help for troubleshooting information.
z
z
The original stops feeding in the middle of faxing
z
The all-in-one is receiving faxes but not sending them
z
Outgoing fax calls keep dialing
z
Faxes that you send are not arriving at the receiving fax machine
z
All of the numbers in a long fax number cannot be dialed
z
Voice calls are not being received by the phone that is connected to the line
z
Voice calls are not being received by the phone that is connected to the line
z
Incoming fax calls are not being answered by the all-in-one
z
Faxes are transmitting or being received very slowly
z
Faxes are not printing or are printing incorrectly
z
Faxes are printing on two pages instead of one
z
Received faxes are too light or are printing on only half of the page
z
General problems with faxing
z
Check the fax setup
• Make sure that you are using the phone cord that was supplied with the all-in-one. The
all-in-one has been tested with the supplied cord, and the cord was proven to meet
product specifications.
• Make sure that the phone cord is installed in the correct port on the all-in-one. It should
be plugged into the (line-in) port. See
Connecting the all-in-one to a phone line
for
more information.
• Make sure that the phone cord is seated in the port on the back of the all-in-one. Gently
pull on the cord to make sure that it is well seated in the correct port.
• Make sure that the telephone jack is working correctly. Attach a phone to the jack on
the wall and verify that a dial tone exists and that you can make a phone call.
• If you use third-party software to send faxes from a Macintosh computer, make sure
that the fax queue settings are correct for your operating system and connection type.
For Macintosh computers connected directly to a computer with a USB cable using
CommApp, use the Officejet 9100 series Fax fax queue for Mac OS 9. For Mac OS
10, use the Officejet 9100 series (Fax) fax queue.
Note
Parallel or “T” splitters should not be used with the all-in-one, as they can degrade the quality
of the phone signal. If you need to attach a second device to the phone line along with the
all-in-one, plug the second device into the
(phone) port on the back of the all-in-one. See
Connecting an additional telephone device
for more information.