HP A7818-IE002 - Manual (Page 94)

Tests And Error Messages
Error Message Summary
Chapter 4 94
The following table summarizes the most significant problems that can be reported.
0310h Floppy A: not detected (but configured in CMOS) Flexible disk drive error
0311h Floppy B: not detected (but configured in CMOS) Flexible disk drive error
0306h General failure on floppy controller Flexible disk drive error
0400h CD-ROM test failure CD-ROM error
0401h CD-ROM not detected (but configured in CMOS) CD-ROM error
0500h General failure on HDD onboard primary ctrl IDE device error
0501h General failure on HDD onboard secondary ctrl IDE device error
0510h HDD # 0 self-test error IDE device # 0 error
0520h HDD # 0 not detected (but configured in CMOS) IDE device # 0 error
0521h HDD # 1 not detected (but configured in CMOS) IDE device # 1 error
0522h HDD # 2 not detected (but configured in CMOS) IDE device # 2 error
0523h HDD # 3 not detected (but configured in CMOS) IDE device # 3 error
0530h Found a drive on slave connector only (primary) IDE device error
0531h Found a drive on slave connector only (secondary) IDE device error
0600h Found less video memory than configured in
CMOS Video memory error
0700h Found less DRAM memory than at previous boot System memory error
0711h Defective SIMM (module 1, bank 1) System memory error
0800h Found lower cache size than configured System cache error
0801h Cache self-test failure System cache error
0A00h Plug and Play (PnP) video auto-setting failure
(DDC hang) DDC video error
Code # Cause/Symptom Short message (US)
Message Explanation or Suggestions for Corrective Action
Operating system not found • Check whether the disk, HDD, FDD, or CD-ROM drive is
connected.
• If it is connected, check that it is detected by POST.
• Check that your boot device is enabled on the Setup Security
menu.
• If the problem persists, check that the boot device contains the
operating system.
Missing operating system If you have configured HDD user parameters, check that they are
correct. Otherwise, use HDD type “Auto” parameters.