HP A7818-IE002 - Manual (Page 151)

Installing Or Replacing Parts And Accessories
Replacing The Battery
Chapter 6 151
Replacing The Battery
WARNING There is a danger of explosion if the battery is incorrectly installed. For your
safety, never attempt to recharge, disassemble, or burn the old battery.
Replace the battery only with the same or equivalent type recommended by
the manufacturer. The battery is a lithium battery which does not contain
heavy metals. Nevertheless, in order to protect the environment, do not
dispose of batteries in household waste. Please return used batteries to the
shop from which you bought them, or to the dealer from whom you purchased
your workstation, or to HP, so that they can be either recycled or disposed of in
an environmentally sound way. Returned batteries will be accepted free of
charge.
If your workstation repeatedly loses its configuration settings you should consider
changing the battery. Replace it with a CR2032 coin type manganese/lithium battery,
available from most workstation stores.
To change the battery:
1. Disconnect the workstation’s power supply cord and any connection to a
telecommunications network.
2. Remove the workstation’s cover (refer to page 119).
3. Remove the old battery by sliding it from under the retaining clip(s).
Figure 6-26 Replacing the Battery
4. Place the new battery in the battery holder and ensure that it is properly seated.
Ensure that the clip holds the battery firmly in place.
5. Replace the workstation’s cover (refer to page 119). Reconnect all cables and power
cords.
6. Run the Setup program to reconfigure the workstation.
Location of battery