HP A7818-IE002 - Manual (Page 118)

Installing Or Replacing Parts And Accessories
Overview
Chapter 6 118
Overview
This chapter provides information about installing accessories and replacing hardware
parts in your HP Workstation x2100.
Figure 6-1 Workstation
Contact your dealer for an up-to-date list of supported devices or check the HP web site:
www.hp.com/go/workstationsupport .
Figure 6-2 HP Workstation x2100 System Board
Front access shelves:
Three 5.25-inch drive
shelves (can be used for
optical drives or with a
3.5 tray kit available as
accessory)
Two 3.5-inch shelves
including a 1.44 MB
floppy disk drive
Power Supply Unit
Primary Hard Disk
Drive Shelf
Secondary Hard
Disk Drive Shelf
Spare mounting rails:
Wide green rails for
5.25-inch devices (for
example, zip drive)
Narrow green rails for
3.5-inch devices
Blue rails for 3.5-inch
hard disk drives
Main Fan
Chassis Beam
Processor (heatsink
not shown)
Floppy Disk
Drive Connector Secondary IDE
Connector
Primary IDE
Connector
Up to six accessory cards can be
installed:
One AGP PRO 4X slot (graphics)
Five 32-bit workstation slots
Memory module sockets supporting four
RDRAM modules