HP A7818-IE002 - Manual (Page 124)

Installing Or Replacing Parts And Accessories
Installing Or Replacing An Accessory Card
Chapter 6 124
a. Make sure the green retainer clip is installed on the post as shown in Figure 6-6.
To move or adjust the clip, squeeze the locks on each side of the clip and slide it
in or out. Before installing the beam, adjust the clip to be as close to the beam as
possible.
Figure 6-6 Retainer Clip on the Chassis Beam Assembly
b. Hook the chassis beam assembly to the left side of the chassis and replace the
screw that holds the chassis beam assembly to the chassis.
c. Adjust the retainer clip by using your index fingers to squeeze the locks and slide
the retainer clip against the AGP graphics card making sure the card edge is
firmly in the retainer clip slot. The retainer clip should push snugly against the
graphics card edge.
7. If you are installing or replacing a SCSI card, reconnect the disk activity LED
connector to the system board (refer to for the location of the system board
connectors).
8. Install any other accessories before replacing the cover (refer to page 119). Reconnect
all cables and power cords.
The retainer clip
keeps the
graphics board
seated on the
system board
when the chassis
beam assembly is
installed.
Retainer clip
Squeeze locks to adjust
Clip inserted on
post and adjusted to
be as close to beam
as possible. After
Retainer clip slot
beam is installed,
adjust clip to push
snugly against
graphics card edge.