Native Instruments MASCHINE+ Standalone Production and Performance Instrument - Manual (Page 92)

10.6.3. Page 3: FX / Filter
Sampler parameters – page 3 of 6: FX and FILTER
FX
This is a small selection of basic effects, not to be mixed up with the collection of Effect Plug-ins
covered in depth in chapter Using Effects .
Parameter Description
FX
Comp
Basic compressor allowing you to give a Sound more density.
Drive Defines the amount of saturation applied to a Sound.
SR SR stands for “sample rate”: you can use it to lower the original sample rate in
order to make the Sound more lo-fi.
Bits Allows you to lower the original bit depth of the Sound, resulting in a more
rough, digital sounding lo-fi effect.
FILTER
The Filter selector in the FILTER section gives you access to a set of different filters. Using the
arrows or clicking the type currently displayed, you can choose from different filter type settings:
Off , LP2 , BP2 , HP2 , and EQ . Each type results in different parameters to the right of it:
Filter
Modes
Description
Off No filter.
LP2 LP2 is a low-pass filter with Cutoff and Resonance parameters. Cutoff can be
modulated by Velocity, the Modulation Envelope, the LFO or the MIDI
Modulation Wheel.
BP2 BP2 is a band-pass filter with a Cutoff parameter. Cutoff can be modulated by
Velocity, the Modulation Envelope, the LFO or the MIDI Modulation Wheel.
HP2 HP2 is a high-pass filter with Cutoff and Resonance parameters. Cutoff can be
modulated by Velocity, the Modulation Envelope, the LFO or the MIDI
Modulation Wheel.
EQ The EQ is an equalizer with Frequency , Bandwidth and Gain parameters.
WORKING WITH PLUG-INS
85