Native Instruments MASCHINE+ Standalone Production and Performance Instrument - Manual (Page 41)

The displays showing the Audio page from the Group’s OUTPUT properties.
Using the Navigate Mode
Alternatively, you can also navigate Channel properties and Plug-ins along with their Parameter
pages via the Navigate mode :
1. Press SHIFT + VARIATION to enter Navigate mode (or pin it by pressing NAVIGATE +
Button 1).
2. Hold SHIFT + VARIATION , then Button 2 ( PAGE NAV ) to enter Page Navigation mode.
3. Press the CHANNEL button to display the Channel properties or the PLUG-IN button to
display the Plug-in slots of the selected Sound, Group, or the Master.
4. Press Button 5/6 to navigate the Channel properties or Plug-ins. The name of the selected
Channel properties or Plug-in appears between the left and right arrows under Button 5 and 6.
Furthermore, this Plug-in or set of Channel properties is highlighted on the left display.
5. Press the dimmed pads to select the desired Parameter pages. The names of the available
Parameter pages are shown on the right display along with the corresponding pads.
6. Upon your selection, the corresponding pad turns fully lit and the page name is highlighted on
the right display.
7. If there are more than 16 Parameter pages, press Button 7/8 to switch to the previous/next 16
pages.
8. Release the VARIATION button to get back to Control mode (or press VARIATION ) a second
time if you pinned the Navigate mode).
→ The selected Parameter page now appears on the displays. Use Knobs 1–8 under the
displays to adjust the parameters.
6.7. Adjusting Volume, Swing, and Tempo
At any time you can quickly adjust volume levels, swing, and the overall tempo of your Project
using the Quick Edit buttons.
Adjusting Volume
▶ Press the VOLUME button near the 4-D encoder.
→ The VOLUME button lights up. You can now adjust the volume for your overall Project, for
each Group, and for each Sound individually using the 4-D encoder:
• To adjust the overall volume, turn the 4-D encoder. Hold SHIFT to adjust the value in finer
increments.
• To adjust the volume of a particular Group, hold its Group button ( A – H ) and turn the 4-D
encoder. Hold SHIFT to adjust the value in finer increments.
COMMON OPERATIONS
34