Native Instruments MASCHINE+ Standalone Production and Performance Instrument - Manual (Page 199)

The SLICE page 1
18.4.3. Adjusting the Slicing Settings
At the bottom of the left display, you can adjust the settings used to define where the various
Slices will be created in the Sample.
Any change to these settings will directly affect the number and position of the Slice markers
shown in the waveform on the displays.
Selecting and Pre-Listening the Slices with the Pads
At any time, the proposed Slices are also available on your pads: The fully lit pad indicates the
selected Slice, while the dim-lit pads indicate the other Slices.
▶ Press any fully or dim-lit pad to play back the corresponding Slice on the Cue bus.
If there are more than 16 Slices, you can select which set of 16 Slices should be triggered by your
pads:
▶ If there are more than 16 Slices, press SHIFT + Button 7 or 8 to switch your pads to the
previous/next 16 Slices.
Note that we haven’t applied any slicing yet: For now your pads only allow you to prelisten
how the proposed would sound after you apply the slicing. Applying the slicing will be
described in section Applying the Slicing .
Slicing Parameters
The following parameters are available:
Parameter Description
TIME Section
SAMPLING AND SAMPLE MAPPING
192