Native Instruments MASCHINE+ Standalone Production and Performance Instrument User Manual
Page 40
Once the Sound is focused you can use Button 1–3 above the left display to quickly
switch between the Master, the containing Group, and the focused Sound. See section
Switching Between the Master, Group, and Sound Level
for more information.
You can also select multiple Sounds at once to apply changes to all of them. See section
Selecting Multiple Sounds or Groups
for more information.
6.5. Switching Between the Master, Group, and Sound Level
At any time you can quickly switch the Control view between the parameters of the Master, the
focused Group, or the focused Sound.
1.
Press the
CHANNEL
or
PLUG-IN
button to enter Control mode.
2.
Press Button 1 (
MASTER
), Button 2 (
GROUP
), or Button 3 (
SOUND
) above the left display to
show the Plug-in parameters and Channel properties of the Master, the focused Group, or the
focused Sound, respectively.
→
The selected tab lights up. The name of your Project, the focused Group, or the focused
Sound appears on the left display (under the
MASTER
,
GROUP
, and
SOUND
tabs), and the
displays show the Plug-in parameters and Channel properties of the Master, the focused
Group, or the focused Sound, respectively.
6.6. Navigating Channel Properties, Plug-ins, and Parameter
Pages
This section describes how to display/edit any Plug-in parameters or Channel properties located in
any Sound, Group, or the Master.
Navigating Channel Properties, Plug-ins, and Parameter Pages
To navigate Channel Properties, Plug-ins, and Parameter Pages:
1.
Set the focus on the desired Sound, Group, or the Master (see section
).
2.
Press the
CHANNEL
button to display the Channel properties or the
PLUG-IN
button to
display the Plug-in slots of the selected Sound, Group, or the Master.
3.
Press Button 1 (
MASTER
), Button 2 (
GROUP
), or Button 3 (
SOUND
) to display the Plug-ins and
Channel properties of the Master, the focused Group, or the focused Sound.
4.
Use the 4-D encoder or press Button 5/6 to navigate the Channel properties or Plug-ins (the
name of the selected Channel properties or Plug-in appears between the left and right arrows
under Button 5 and 6). The parameters of the selected Channel properties or Plug-in are
shown on the displays.
5.
Use the
Page buttons
(underneath the
BROWSER
and
SAMPLER
buttons) to navigate
through the Parameter pages of the selected Channel properties or Plug-in. Moreover, if there
is another page available to the left or to the right of the current page, the corresponding Page
button will be half-lit.
6.
Use Knobs 1–8 under the displays to adjust the value of the parameters available on the
selected page. For continuous parameters, hold
SHIFT
while turning the Knobs to adjust the
values in finer increments.
COMMON OPERATIONS
33