Native Instruments MASCHINE+ Standalone Production and Performance Instrument - Manual (Page 111)

1. Press button A on the left to select the first Group slot. This is where you are going to load the
drum kit. Button A should be lit to indicate that it is selected.
2. Press the BROWSER button.
→ The BROWSER button lights up. In the left display, you now are presented with a selection of
choices.
3. Press Button 1 or Button 2 above the displays to select GROUPS .
→ A list of Groups appears on the right display:
4. Check that Button 4 above the displays is not fully lit and that the USER label underneath is
not highlighted; if necessary, press Button 4 to disable it.
→ This will now allow you to select only Native Instruments factory content.
5. Move the 4-D encoder to the left or to the right in order to put the focus (indicated by the
brackets) on All Types .
6. Press and hold the 4-D encoder to view which Group types are available.
→ The right display shows the various types of Groups available ( Kits , Loops , Multi FX ) as long
as the 4-D encoder is pressed:
7. While holding the 4-D encoder, turn it to select Kits .
→ When you release the encoder, the right display shows the list of Groups again, but now this
list contains only drum kits. Note that you can also turn the 4-D encoder without holding it to
select the desired entry (the available types of Groups will not be displayed).
8. Move the 4-D encoder one step to the right to put the focus (the brackets) on the All Sub-
Types label that just appeared.
RECORDING PATTERNS
104