Native Instruments MASCHINE+ Standalone Production and Performance Instrument - Manual (Page 58)

7.3.4. System Settings
The System settings enable you to update the MASCHINE+operating system, switch to Storage
mode to exchange data between the SD card in MASCHINE+ and your computer, or enter
Controller mode to use MASCHINE+ as a controller for the MASCHINE software running on a
computer.
Using the SHIFT you can also find National options to reset your MASCHINE+, and manually scan
for system updates.
To display the System settings page:
1. Press SETTINGS .
2. Use the 4-D encoder to select System .
3. Use the Buttons 1–8 to change settings.
4. Press SHIFT to see additional settings.
The Device page provides the following settings:
Setting Description
STORAGE Allows you to access the SD card within your MASCHINE+ when connected
via USB. In this mode, you can transfer content between MASCHINE+ and
your computer. For more information on Storage mode, see Using
MASCHINE+ in Storage Mode .
CONTROLLER Activates Controller mode. In Controller mode MASCHINE+ can be used as a
controller for the MASCHINE software, where all processing is performed by
the connected computer. It is possible to start exchange Project files and
samples between MASCHINE+ and your computer using Storage mode. This
means you could effectively, for example, start a Project on MASCHINE+ and
then finish later on your computer using the MASCHINE software.
To use Controller mode, your MASCHINE+ must be connected via USB to a
computer that is running the latest MASCHINE software. For more
information on Controller mode, see Stand-Alone vs. Controller Mode .
UPDATE Enables you to update the MASCHINE+ operating system whenever a new
version is available. When connected to Wi-Fi, MASCHINE+ automatically
checks for updates when the System page is accessed. Press Button 8 to
install system updates when they become available.
MASCHINE software and MASCHINE+ are constantly being
developed. To receive new features and improvements, it is
recommended that you install the latest updates.
Here are the additional settings that are available when pressing SHIFT :
WORKING WITH MASCHINE+
51