Panasonic AV-HS6000 2 M/E Live Switcher Main Frame & Control Panel (Dual Redundant Power Supplies) User Manual
Page 21
– 21 –
Chapter 3 Part Names and Functions — Main Frame AV‑HS60U1/AV‑HS60U2
5
Connects the Control Panel AV-HS60C1/AV-HS60C2/AV-HS60C4.
6
×
2/signal: Genlock)
Loop-through output in the external sync mode. If the loop-through output is not going to be used, provide a 75
Ω
termination.
Black burst signals are output from both terminals in the internal sync mode.
7
This is the LTC (linear time code) input terminal.
8
×
3, inch screw/signal: RS‑422)
Used for master connection of external devices. (page 171)
9
Used for master connection/slave connection of external devices. (page 171)
f
Master connection and the slave connection can be switched from the
→
[PERIPHERAL]
→
[General] tab
→
[MF
COM4] column
→
10
Equipped with 18 contact input ports (GPI IN) that control the unit externally, and an alarm output port (ALARM OUT). (page 170)
11
×
2, inch screw/signal: GPI OUT)
12
Connects to the ground of the system.
13
(Fuse)
14
Connects one end of the supplied AC cable to this terminal and the other end to the AC outlet. (AC 100 V to 240 V, 50 Hz/60 Hz)
f
The supplied AC cable has a 3-pin plug with a grounding terminal. Connect to a 3-pin power outlet which is equipped with a grounding terminal.
f
If a 3-point power outlet is not available, be sure to consult your dealer.
@
@
NOTE
t
For the cable connecting to the
terminal, use a 5C-FB compliant double-shielded cable.
t
For the cable connecting to the
t
For the cable connecting to the
terminal, or