Panasonic AV-HS6000 2 M/E Live Switcher Main Frame & Control Panel (Dual Redundant Power Supplies) - Manual (Page 141)

– 141 –
Chapter 8 System Menu — System settings
System settings
For details of operation in the 3G mode or the 4K mode, refer to “Difference of function for each mode” (page 164).
Setting the video format function
One system format (input/output signal) can be selected.
@ @ NOTE
t Do not change the format during any of the following operations:
- When loading from a memory card or saving to a memory card
- When loading from the Storage Module AV-HS60D1 or saving to the Storage Module AV-HS60D1
- When recording videos or still images
1
Select the button → [SYSTEM] → [Video] tab.
2
Select an item in [Video Format] in the [Video Format] column.
f Select a system format. Selectable items are as follows:
- Standard mode:
[1080/59.94i], [1080/50i], [1080/24PsF], [1080/23.98PsF], [720/59.94p], [720/50p], [480/59.94i], [576/50i], [1080/29.97PsF], [1080/25PsF]
- 3G mode
[1080/59.94p], [1080/50p]
- 4K mode
[2160/59.94p], [2160/50p]
3
Select an item in [16:9 Squeeze] in the [Video Format] column.
f This setting is enabled when SD is selected as the system format.
f When [16:9 Squeeze] is set to [On], a border width (wipe or PinP), which considers cases where SD format videos are converted to the 16:9
aspect ratio before use, is established.
[Off] Squeeze mode is not supported.
[On] Squeeze mode is supported.
r Border width (graphical representation) when squeeze mode is supported
Squeeze (4:3) 16:9
Setting the output phase
The phase of the output video signals can be adjusted.
1
Select the button → [SYSTEM] → [Video] tab.
2
Select an item in [System] in the [Output Phase] column.
[1H]
Outputs video signal with 1H delay against the system sync signal. When the frame synchronizer function is on, the
video signal is output with delay of 1 frame + 1H.
[0H]
Output video signals are output in phase for the system sync signal. The frame synchronizer function is ON for all input
signals.
3
Select an item in [H‑Phase[H]] in the [Output Phase] column.
f Adjust the H phase. It can be adjusted to a value from [ − 0.50H] to [0.49H].
4
Select an item in [V‑Phase [Line]] in the [Output Phase] column.
f Adjust the V phase. It can be adjusted to a value from [ − 100H] to [100H].
r Phase adjustment setup
f The line synchronizer range is the draw-in range in which automatic phase adjustment is possible. The following illustration shows that the signal is
1080/59.94i.