Panasonic AV-HS6000 2 M/E Live Switcher Main Frame & Control Panel (Dual Redundant Power Supplies) - Manual (Page 103)

– 103 –
Chapter 5 Basic Operations — Video memory
Video memory
The unit can store and use the still image memory (Still) and the moving image memory (Clip), each in four channels.
f Images with key signals can be saved in the video memory (still images and moving images).
f With the standard image quality, up to approximately 60 seconds of video (1800 frames in 1080/59.94i, 480/59.94i, 1500 frames in 1080/50i, 576/50i,
3600 frames in 720/59.94p, and 3000 frames in 720/50p) can be saved in the moving image memory per channel. With the high image quality mode,
up to approximately 30 seconds of video (900 frames in 1080/59.94i, 480/59.94i, 750 frames in 1080/50i, 576/50i, 1800 frames in 720/59.94p, 1500
frames in 720/50p) can be saved in the moving image memory per channel.
f The number of seconds which can be saved in the moving image memory varies depending on the system format (frame rate).
f Audio data can be saved in the moving image memory.
f If the power is turned off or if the video format is changed, the data in the video memory will be deleted.
f Data of the video memory can be saved to and read from the Storage Module AV-HS60D1 (optional) installed on the Main Frame AV-HS60U1/
AV-HS60U2, a memory card of the control panel connected to the terminal, and computer connected to the terminal.
Main Frame
terminal
terminal
Still 1V
Still 1K
Still 2V
Still 2K
Still 3V
Still 3K
Still 4V
Still 4K
Clip 1V
Clip 1K
Clip 2V
Clip 2K
Clip 3V
Clip 3K
Clip 4V
Clip 4K
From XPT
VMEM F
VMEM S
To XPT
STILL V/K 1 to 4
1 frame
(volatile memory)
CLIP V/K 1 to 4
High image quality: Approx. 30 sec
Standard image quality: Approx. 60 sec
(volatile memory)
Storage Module (SSD)
Still Register: Max. 81
Clip Register: Max. 81
(non-volatile memory)
Control Panel
Local computer
Memory card
Storage
@ @ NOTE
t There is a limitation on the function when the switcher mode is set to the 3G mode or the 4K mode. For details on the 3G mode or the 4K mode, refer
to “Difference of function for each mode” (page 164).
Recording still images (Still)
Input images selected on the VMEM F/S buses can be recorded.
f Image data created using a computer can be loaded.
For details, refer to “Operating the register memory” (page 105).
f This operation can be also performed in the multi-selection panel area.
For details, refer to “Video memory menu” (page 43).
1
Select the button → [STILL] → [Still] tab.
2
Select [Still1] to [Still4] in [Current Still], and select [Rec] in the [Rec1] column.
f When [Rec] is selected in the [Rec1] column, the source selected on the VMEM bus is recorded as still images for the selected channel.
When the recording of the still images is completed, thumbnails of the still images are displayed on the thumbnail screen.
Various settings when recording still images (Still)
1
Select the button → [STILL] → [Still] tab.
2
Select an item in [Key Enable] in the [Rec1] column.
f Set whether to record key signals at the same time.
[Off] Does not record the key signals.