Panasonic AV-HS6000 2 M/E Live Switcher Main Frame & Control Panel (Dual Redundant Power Supplies) - Manual (Page 120)

– 120 –
Chapter 6 Input/Output Signal Settings — Setting input signals
@ @ NOTE
t When the frame synchronizer function is [Off], if [Dot by Dot], [U/C], and [Auto] are set, the frame synchronizer function is automatically set to [Strict].
t When [Freeze] is set to [On] in the [SDI IN 1] to [SDI IN 32] columns, the input mode cannot be changed.
Setting the delay amount
The input signals can be delayed.
f This function is enabled when [FS] in the [SDI IN 27]/[SDI IN 28]/[SDI IN 31]/[SDI IN 32] column is set to an item other than [Off].
1
Select the button → [SDI IN] → [Frame Buffer] tab.
2
Set [Frame delay] in the [SDI IN 1] to [SDI IN 32] columns.
f Set the input signal delay amount in a range between [0F] and [8F].
Freezing input signals
The input signals can be frozen and used. While signals are frozen, the tally signals of the corresponding input will not be output.
Setting the freeze mode
1
Select the button → [SDI IN] → [Frame Buffer] tab.
2
Select an item in [Freeze Mode] in the [SDI IN 1] to [SDI IN 32] columns.
f An item can also be selected while an image is frozen.
[Frame] Freezes the images frame by frame.
[Field]
Freezes the images field by field.
This is used to freeze moving images. With interlace signals, however, diagonal lines appear jagged.
Setting freeze
1
Select the button → [SDI IN] → [Frame Buffer] tab.
2
Select an item in [Freeze] in the [SDI IN 1] to [SDI IN 32] columns.
[On] Freezes the input signals.
[Off] Does not freeze the input signals.
f The [F] mark appears in front of the source name when the signals set for output of MultiView displays are frozen.
f When the unit is used with the frame synchronizer function [Off], the output images may be disturbed when freezing is executed, but the frozen
images will not be adversely affected.
f If the freeze setting is set to [On] while the frame synchronizer function is set to [Off], the frame synchronizer function is automatically set to [Strict].
Setting the source name
The source names displayed on the Control Panel AV-HS60C1/AV-HS60C2/AV-HS60C4 and the MultiView display can be set from the button
on the top menu
→ [SOURCE NAME] → [Panel Name]/[MV Name] tab.
For details, refer to “Setting the source name” (page 132).
Setting the up‑converter
In the [SDI IN 27], [SDI IN 28], [SDI IN 31], [SDI IN 32] columns, configure the built‑in up‑converter setting.
1
Select the button → [SDI IN] → [Up Converter] tab.
2
Select an item in [Scale] in the [SDI IN 27]/[SDI IN 28]/[SDI IN 31]/[SDI IN 32] column.
f Select the scaling system.
Item Description
Input image
(SD)
System image
(HD)
[Squeeze]
Enlarges the image both horizontally and vertically to fill the
entire screen.
[Edge Crop]
Maintains the aspect ratio of the image, and enlarges the
image in accordance with the vertical resolution. Black images
are added at the left and right.
[Letter Box]
Maintains the aspect ratio of the image, and enlarges the
image in accordance with the horizontal resolution. The image
is cropped at the top and bottom.