Avago Technologies Cache Protection for RAID Controller Cards - Manual (Page 99)

Avago Technologies
- 99 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015 Chapter 2: Installing the Cache Backup Products
Attaching the CVFM03 Module to a MegaRAID SAS 9265CV-8i RAID Controller and
Connecting to a Remote CVPM02 Module
2.10.3 Installing the Clip Directly on the Remote Mount Board
Follow these steps to install the clip directly on the remote mount board.
1. Place the remote mount board on a flat, clean, static-free surface.
2. Ground yourself and make sure the system is grounded.
3. Remove the clip and the remote mount board module from the package.
4. Place the clip and the remote mount board module front-side-up on a flat, clean, static-free surface.
5. Hold the clip to line up the screw holes on the clip with the screw holes on the remote mount board, as shown in
the following figure.
Figure 67 Installing the Clip Directly on the Remote Mount Board
6. Secure the clip to the CVPM02 module in three screw holes with the screws and the nuts.
The screws thread through the front of the clip and the remote mount board.
NOTE Center the screwdriver carefully to avoid stripping the screw heads.
Do not overtighten the screws.
A
A
A
Clip
3_00895b-00