Avago Technologies Cache Protection for RAID Controller Cards User Manual
Page 89

Avago Technologies
- 89 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015
Chapter 2: Installing the Cache Backup Products
Connecting a CVFM01 Module on a MegaRAID SAS 9260 RAID Controller to a Remote
CVPM01 Module
2.8.2
Connecting the CVFM01 Module on a MegaRAID SAS 9260 RAID Controller to a CVPM01
Module
To connect the CVFM01 transportable memory module on the RAID controller to a remote CVPM01 module, follow
these steps.
1.
Mount the CVFM01 unit to the chassis of your computer based on the location and the type of mounting option.
NOTE
Because server and workstation chassis vary from vendor to vendor,
no standard mounting option for the CVPM01 unit exists that is
compatible with the various system configurations. Authorized
resellers and chassis manufacturers can customize the location of the
super-capacitor pack to provide the most flexibility within
various environments.
2.
With the controller on a flat, clean, static-free surface, ground yourself, and make sure the system is grounded.
3.
Remove the cable included in the RAID controller box.
4.
Insert one end of the cable into the 15-pin P3 cable connector on the CVFM01 module, and the other end into the
15-pin P1 cable connector on the remote CVPM01 module, as shown in the following figure.
Align the recessed triangle indicators on the connectors to make sure they are connected correctly.
CAUTION
The cable connectors are polarized and can be inserted into the
connectors on the memory module and the remote super-capacitor
pack only if the rails on the cable connectors align with the slots on the
other connectors. Do not force the cable into the 15-pin connectors.
The cable end inserts into the connector with minimal resistance.
Figure 59 Connecting the CVFM01 Memory Module on a MegaRAID SAS 9260CV-8i RAID Controller to the Remote
CVPM01 Module
85081-03
T/N 221038 00135 T/N 221038 00135
S/N
021038 00000140
S/N021038 00000140