2 models of the cachevault power modules – Avago Technologies Cache Protection for RAID Controller Cards User Manual
Page 10

Avago Technologies
- 10 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015
Chapter 1: Introduction
CacheVault Flash Modules and CacheVault Power Modules
1.4.2
Models of the CacheVault Power Modules
Avago offers two models of the CacheVault Power Modules:
The CVPM01 module is a super-capacitor pack that connects remotely by cable to a CVFM01 module that is
installed on a RAID controller.
The CVPM02 module is a super-capacitor pack that is installed on a remote mount board, and connects remotely
by cable to a CVFM02, CVFM03, or CVFM04 module that is installed on a RAID controller.
ATTENTION
You cannot hot-plug CVPM modules. Removing or inserting a
CVPM module with the server powered on damages the board and the
super-capacitor functionality. To attach or remove a CVPM module
from a controller, you must fully power down the controller before you
attach the module to or remove the module from its mating
connector.
The following table lists and describes the CacheVault Power Modules, and identifies the RAID controllers that
use them.
Table 3 MegaRAID CacheVault Power Modules Matrix
CVFM Product Name
Description
For RAID Controllers
For Use With
CVPM01
Super-capacitor pack on printed circuit
board
MegaRAID SAS 9260CV-4i
MegaRAID SAS 9260CV-8i
CVFM01 module
(installed on a RAID
controller)
CVPM02
Super-capacitor pack installed on a clip
that is installed on a remote mount board
MegaRAID SAS 9266-4i
MegaRAID SAS 9266-8i
CVFM02 module
(installed on a RAID
controller)
MegaRAID SAS 9265CV-8i
MegaRAID SAS 9285CV-8e
CVFM03 module
(installed on a RAID
controller)
MegaRAID SAS 9361-4i
MegaRAID SAS 9361-8i
MegaRAID SAS 9380-4i4e
MegaRAID SAS 9380-8e
CVFM04 module
(installed on a RAID
controller)