Avago Technologies Cache Protection for RAID Controller Cards - Manual (Page 54)

Avago Technologies
- 54 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015 Chapter 2: Installing the Cache Backup Products
Installing the LSIiBBU07 Unit
2.4.6.2 Installing the Board-to-Board Cable Adapter Card on the RAID Controller
Follow these steps to install the board-to-board cable adapter card on the controller, as shown in the following figure.
1. With the controller on a flat, clean, static-free surface, ground yourself, and remove the adapter card, standoff, and
screws from the package.
2. Place the standoff on the controller so that the bottom side is positioned over the screw hole next to the J1
connector on the controller.
3. Use one of the screws to secure the standoff to the controller.
NOTE Center the screwdriver carefully to avoid stripping the screw head.
Do not overtighten the screws.
4. Hold the adapter card so that the J2 board-to-board connector on the adapter card lines up with the J10
board-to-board connector on the RAID controller.
5. Carefully press the J2 connector on the adapter card into the J10 connector on the controller so that the two
connectors are joined firmly.
6. The connectors fit only when they are in the correct alignment.
7. Use the other screw to secure the adapter card to the controller, and continue with the next procedure.
Figure 32 Connecting the Board-to-Board Cable Adapter Card to the RAID Controller
85059-01
J1