Avago Technologies Cache Protection for RAID Controller Cards User Manual
Page 45

Avago Technologies
- 45 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015
Chapter 2: Installing the Cache Backup Products
Installing the LSIiBBU07 Unit
2.4.2.3
Reinstalling the RAID Controller on the Motherboard
Follow these steps to reinstall the RAID controller on a motherboard.
1.
With the power to the chassis still turned off, and the power cords unplugged, make sure that the chassis is
grounded and has no AC power.
2.
Insert the RAID controller in a PCI Express® slot on the motherboard, as shown in the following figure.
NOTE
This controller is a PCIe x8 card, and it can operate in x8 or x16 slots.
Some PCIe slots, however, support only PCIe graphics cards; if a
controller is installed in one of these slots, the controller will not
function. Refer to the guide for your motherboard for information
about the PCIe slot.
3.
Press down gently, but firmly, to seat the RAID controller correctly in the slot.
CAUTION
Never apply pressure to the LSIiBBU07 unit when you insert the RAID
controller. Instead, press down only on the top edge of the
RAID controller.
Figure 26 Reinstalling the MegaRAID SAS RAID Controller
4.
Secure the controller to the computer chassis with the bracket screw.
5.
Replace the computer cover and reattach the power cords.
6.
Turn on the power to the computer.
Edge of Motherboard
LSIiBBU07 (Top View)
Bracket Screw
Edge of
Motherboard
Press Here
85021-04
Press Her e