Avago Technologies Cache Protection for RAID Controller Cards - Manual (Page 56)

Avago Technologies
- 56 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015 Chapter 2: Installing the Cache Backup Products
Installing the LSIiBBU07 Unit
2.4.6.4 Reinstalling the RAID Controller
Follow these steps to reinstall the RAID controller in the host computer.
1. With the power to the chassis still turned off and the power cords unplugged, make sure that the chassis is
grounded and has no AC power.
2. Insert the RAID controller into a PCIe slot on the motherboard, as shown in the following figure.
NOTE This controller is a PCIe x8 card, and it can operate in x8 or x16 slots.
Some PCIe slots, however, support only PCIe graphics cards; if a
controller is installed in one of these slots, the controller will not
function. Refer to the guide for your motherboard for information
about the PCIe slot.
3. Press down gently, but firmly, to seat the controller correctly in the slot.
4. Secure the controller to the computer chassis with the bracket screw.
Figure 34 Reinstalling the RAID Controller
Edge of Motherboard
Press
Here
3_00721-00
Screw
Press
Here