Avago Technologies Cache Protection for RAID Controller Cards - Manual (Page 111)

Avago Technologies
- 111 -
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
May 2015 Chapter 2: Installing the Cache Backup Products
Attaching the CVFM04 Module to the RAID Controller and by Cable to a CVPM02 Module on
a Remote Mount Board
2.11.2.7 Installing the Remote Mount Board on the Motherboard
Follow these steps to install the remote mount board on the motherboard.
1. Make sure that the power to the chassis is still turned off, the power cords are unplugged, and the chassis is
grounded and has no AC power.
2. Insert the remote mount board in a PCIe slot on the motherboard, as shown in the following figure.
NOTE Some PCIe slots support only PCIe graphics cards. If a remote mount
board is installed in one of these slots, the remote mount board will
not function. Refer to your computer documentation for information
about the PCIe slot.
3. Press down gently, but firmly, to seat the board correctly in the slot.
4. Use the bracket screw to secure the remote mount board to the system chassis.
Figure 78 Installing the Remote Mount Board
5. Reinstall the computer cover, and reattach the power cords.
6. Turn on the power to the computer.
Refer to the MegaRAID SAS Software User Guide for information on running the RAID configuration utility and the
MegaRAID SAS Device Driver Installation User Guide for information on installing the software drivers.
3_01659-04
Edge of
Motherboard
PCIe Slot
Bracket
Screw
Press
Here
Press
Here
CacheVault
Flash Module 04
(CVFM04)
CacheVault
Power Module 02
(CVPM02)
Remote Mount
Board